Dual 9 way D Userport Joystick for Commodore PET Assembled

This is the PCB to build a dual 9 way D joystick interface for the Commodore PET and Mini PET Userport.

This is constructed with through hole parts (not included). The diodes are used to generate the fire signals, and the resistors protect the userport if it is configured as an output.

The value read is the position information from a standard Commodore / Atari style joystick with the usual pinout:

• 1 = Up
• 2 = Down
• 3 = Left
• 4 = Right
• 5 = N/C
• 6 = Fire
• 7 = N/C
• 8 = GND
• 9 = N/C

There is no power on the userport of the PET, so no autofire etc. 

The value is read from port E841 (59457), and is best calculated using 255-PEEK(59457).

The values returned from this are as follows:

• 0x01 (1) = Port 1 Up
• 0x02 (2) = Port 1 Down
• 0x04 (4) = Port 1 Left
• 0x08 (8) = Port 1 Right
• 0x03 (3) = Port 1 Fire
• 0x10 (16) = Port 2 Up
• 0x20 (32) = Port 2 Down
• 0x40 (64) = Port 2 Left
• 0x80 (128) = Port 2 Right
• 0x30 (48) = Port 2 Fire

This listing is for an assembled dual joystick interface. No PETs, Mini PETs, joysticks or games are included. 

See my other listings for a full kit and PCB only versions.

This is supported under Vice for development as PET userport joystick, and in the following games (and many others):

• https://tynemouth.itch.io/pet-3d-monster-maze
• https://tynemouth.itch.io/tut-tut-commodore-pet

More information on my blog:

• http://blog.tynemouthsoftware.co.uk/2022/08/commodore-pet-dual-userport-joystick.html

Tynemouth Dual 9 way D Joystick for PET Userport V2.0.pdf [1115.72] KB